C-9 Point-To-Point Dial Backup Error Messages - Paradyne COMSPHERE 3610 Operator's Manual

COMSPHERE 3600 Series Data Service Units
Message Notify NMS
DBM: Busy
DBM: Call
Aborted
DBM:Callbck Fail
DBM:
Conflict w/Envir
DBM:Dir Empty
DBM:DTR Discon
DBM:Illegal Char
DBM:NetwkAbort
DBM:NetwkBusy
DBM:NetwkUnavl
DBM:No Answer
1
If Yes, an error message is reported to the NMS if the NMS initiated the Dial command.
C-12
Table C-9
Point-to-Point Dial Backup Error Messages
1
Condition
Yes Telephone line associated
with remote DBM is busy.
No Call was aborted from the
DCP.
No There was a failure to
connect on a callback
attempt.
Yes DBM is not able to dial out
(e.g., test is being run); there
is no DBM at the far end.
Yes An attempt was made to
place a call from an empty
directory.
Yes DTR has gone low, or the
call did not connect.
Yes Illegal character in the
directory specified.
No Call was aborted by the
network.
Yes Call was unable to place call
at the time.
Yes Network is incapable of
passing data.
Yes There was no answer from
the remote DBM or modem.
(1 of 2)
Try again. Try another number if
possible, or investigate why the line is
busy.
None.
Make sure you have the correct call
setup pointer and that remote DBM has
the proper telephone number in that
directory. If both are correct, attempt to
place a manual call from the remote
DBM.
Wait until the test is completed, or abort
the test.
Check Backup Directory entries and
numbers.
Raise DTR at the DTE, or disable the
DTRCallCon configuration option.
Check directory entry.
Try again.
Try again.
Look for line problems. If conditions are
good and no problem is found, call
telephone company and report the
problem.
1. Check that remote DBM is configured
for many calls.
2. Make sure remote DBM is properly
connected to the PSTN.
3. Check operational status of remote
DSU using a Device Test.
4. Attempt to place a call from remote
DBM. If it cannot be placed, replace
the DBM.
July 1999
Action
3610-A2-GB91-90