Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 164

Hard disk drive (HDD) / solid state disk (SSD)
1 SAS/SATA cable
2 SAS/SATA cable
3 Power cable
4 SAS/SATA cable
5 OOB cable
The cables are equipped with labels showing the right connector.
For the cable plan, see
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
Concluding steps
▶ Insert all HDD/SSD modules, see
page 152.
Ensure that you install the HDD module in the bay it was located
before the HDD backplane replacement.
▶ Insert all dummy modules, see
page 155.
▶
"Installing the fan cage" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ Verify that the iRMC S6 recognizes the installed HDDs/SSDs.
▶ If applicable,
"Installing the front cover with lock" on page
164
"Appendix B" on page
"Installing a 3.5-inch HDD module" on
"Installing a 3.5-inch dummy module" on
77.
59.
65.
71.
Upgrade and Maintenance Manual
559.
71.
RX2540 M7