▶ Remove the PSU and install the dummy cover carefully.
Note for PSU 1:
Remove the PSU 1 carefully while lifting PSU 1 and bringing PSU 1
to the right, in order to avoid interference.
▶ Mount the complete assembly (CMA bracket and the CMA) again into the
rail.
Preliminary steps
▶ Only when replacing a PSU in a non-redundant configuration:
down the server" on page
Removing a hot-plug PSU
▶ Remove the power cord from the dedicated PSU, see
power cord" on page
Figure 50: Removing the PSU
▶ Push the handle of the PSU halfway upward in the direction of the arrow (1).
▶ Press in on the green locking latch (2).
RX2540 M7
50.
50.
Upgrade and Maintenance Manual
Power supply unit (PSU)
"Shutting
"Disconnecting the
131