Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 157

Some SSDs / PCIe SSDs have a write life (limited life component). Ask
the customer to check the write status before replacing the spare part. If
the product has reached the end of its life, ask the customer to purchase
it again.
For Japan, refer to the following:
https://jp.fujitsu.com/platform/server/primergy/support/parts/#parts2
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Locating the defective component" on page
Removing the defective 3.5-inch HDD module
▶ Remove the HDD module, see
page 154.
▶ If the new HDD module does not have an installation frame, replace the
installation frame,
page 138.
Installing the new 3.5-inch HDD module
▶ Install the HDD module, see
page 152.
Concluding steps
▶ If applicable,
"Installing the front cover with lock" on page
▶ If the HDD is configured using a RAID controller with a RAID level higher
than "0", the rebuild will start automatically, see
rebuild" on page
▶ For a spare disk, verify that it is set to Hotspare in iRMC S6 web interface.
RX2540 M7
Hard disk drive (HDD) / solid state disk (SSD)
"Removing a 3.5-inch HDD module" on
"Handling HDDs or SSDs without installation frame" on
"Installing a 3.5-inch HDD module" on
108.
Upgrade and Maintenance Manual
47.
48.
"Performing a RAID array
49.
71.
157