Figure 206: Correct position of securing clips
To improve the contact of the memory module perform the following
steps:
▶ Eject the memory module again by pressing out the securing clips at each
end of the memory slot.
▶ Press down on the memory module until the securing clips snap into the
cutouts at each end of the module.
▶ Check if all securing clips are in the correct position, see
Concluding steps
▶
"Installing the air duct" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
RX2540 M7
79.
59.
65.
71.
Upgrade and Maintenance Manual
Main memory
Figure
206.
343