Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 238

Hard disk drive (HDD) / solid state disk (SSD)
Installing the rear 2x 2.5-inch HDD backplane
Figure 123: Installing the rear 2x 2.5-inch HDD backplane
▶ Position the rear HDD backplane.
▶ Fasten the screw (see circle).
▶ Connect the cables to the rear HDD backplane.
The cables are equipped with labels showing the right connector.
For the cable plan, see
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
Concluding steps
▶ Insert all HDD/SSD modules, see
on page 177.
Ensure that you install the HDD/SSD module in the bay it was located
before the HDD backplane replacement.
▶ Insert all dummy modules, see
module" on page
238
"Appendix B" on page
"Installing 2.5-inch HDD/SSD modules"
"Installing a 2.5-inch HDD/SSD dummy
182.
Upgrade and Maintenance Manual
559.
RX2540 M7