Removing The Serial Interface - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

Additional interfaces
▶ Connect the serial interface cable to the connector "Rear Serial" on the
system board (1).
▶ Insert the serial interface cable into the expansion card (2).
Concluding steps
▶ Install the riser module 2, see
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
16.2.2

Removing the serial interface

Upgrade and Repair Unit
(URU)
● Phillips PH2 / (+) No. 2 screw driver (for cover 2)
Tools:
● Hexagon screw driver 5 mm
Preliminary steps
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove the riser module 1, see
482
"Installing a riser module" on page
59.
65.
71.
50.
"Removing a riser module" on page
Upgrade and Maintenance Manual
71.
Hardware: 5 minutes
50.
55.
74.
49.
72.
RX2540 M7