Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 10

Content
5.2.2 Disabling the boot watchdog
5.2.3 Removing backup and optical disk media
5.2.4 Verifying and configuring the backup software solution
5.2.5 Switching on the ID indicator
5.2.6 Checking boot priority
5.3 Completing the maintenance task
5.3.1 Updating or recovering the BIOS and iRMC S6
5.3.2 Verifying system information backup or restore
5.3.3 Updating expansion card firmware
5.3.4 Reconfiguring the backup software solution
5.3.5 Resetting the boot retry counter
5.3.6 Enabling the boot watchdog
5.3.7 Enabling replaced components in the BIOS
5.3.8 Verifying the memory mode
5.3.9 Verifying the system time settings
5.3.10 Viewing and clearing the System Event Log (SEL)
5.3.11 Updating the NIC configuration file in a Linux and VMware
environment
5.3.12 Resuming BitLocker functionality
5.3.13 Performing a RAID array rebuild
5.3.14 Looking for MAC/WWN/GUID and SAS addresses
5.3.14.1 Basic information
5.3.14.2 Looking for the MAC address of a LAN controller
5.3.14.3 Looking for the WWN address of a fibre channel controller
5.3.14.4 Looking for the GUID address of an infiniband or Omni-Path
controller
5.3.14.5 Looking for SAS addresses of SAS controllers for external
devices
5.3.15 Using the Chassis ID Prom Tool
5.3.16 Configuring LAN teaming
5.3.17 Switching off the ID indicator
5.3.18 Performing a fan test
5.3.19 Updating the golden image
5.3.19.1 Updating the golden image for iRMC S6 firmware
5.3.19.2 Updating the golden image for BIOS firmware
5.3.20 Setting boot priority
5.3.21 Recovering the ESXi configuration information encryption
functionality
Upgrade and Maintenance Manual
90
92
92
92
93
94
94
96
98
99
100
101
102
103
104
105
106
107
108
109
109
110
111
112
112
113
115
116
117
117
117
119
120
121
RX2540 M7