Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 69

Figure 20: Connecting the server to the DC voltage - example DC PSU -48 V
▶ Connect the power cord to the PSU (1).
▶ Fasten the two studs (2).
▶ Ensure that the status indicator on the PSU is lit green, see
hot-plug PSU" on page
▶ If necessary, make a permanent connection to the distribution board.
CAUTION
If the server/rack is intended for permanent connection to the mains only
an authorized specialist (electrician) is allowed to work.
▶
Please follow the regulation of each country.
It will take about 60 seconds until the server can be switched on.
RX2540 M7
553.
Upgrade and Maintenance Manual
Basic hardware procedures
"Indicator on
69