Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 201

▶ Position the HDD backplane on the six hooks (see orange circles).
▶ Push the HDD backplane downward. Make sure that the HDD backplane
and the switch board fits into the guide pins.
▶ Fasten the screws (see blue circles).
Figure 98: Connecting cables to the switch board
▶ Connect the following cables to the switch board:
1 Signal cable
2 Power cable
3 Slimline cable
4 Slimline cable
5 Power cable
6 Power cable
7 Slimline cable
8 Slimline cable
The cables are equipped with labels showing the right connector.
For the cable plan, see
RX2540 M7
Hard disk drive (HDD) / solid state disk (SSD)
"Appendix B" on page
Upgrade and Maintenance Manual
559.
201