Replacing A Riser Card - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

▶ Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 106.
▶
"Setting boot priority" on page
▶
"Updating expansion card firmware" on page
▶
"Resuming BitLocker functionality" on page
▶ If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
Configuration of network settings should be performed by the
customer. For more information, see
recovery" on page
▶ If applicable, restore LAN teaming configurations, see
upgrading LAN controllers" on page
9.9.4

Replacing a riser card

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Locating the defective component" on page
RX2540 M7
Expansion cards and backup units
120.
315.
115.
50.
Upgrade and Maintenance Manual
98.
107.
"Note on network settings
"After replacing or
Hardware: 5 minutes
47.
50.
55.
48.
109.
49.
317