Additional interfaces
▶ Loosen the two screws.
▶ Remove the expansion card with the serial interface.
Concluding steps
▶ Install the riser module 1, see
▶ If applicable, install a slot bracket in PCIe slot 5, see
cover with lock" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
16.2.3
Replacing the serial interface
Upgrade and Repair Unit
(URU)
Tools:
– Phillips PH2 / (+) No. 2 screwdriver (for cover 2)
– hexagon screwdriver 5 mm
Preliminary steps
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
Removing the defective serial interface
▶ Remove the serial interface, see
page
482.
484
"Installing a riser module" on page
71.
59.
65.
71.
50.
"Removing the serial interface" on
Upgrade and Maintenance Manual
"Installing the front
71.
Hardware: 5 minutes
50.
55.
74.
49.
RX2540 M7