Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 268

Expansion cards and backup units
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
Removing the defective OCP module
▶ Remove the OCP module, see
Installing the new OCP module
▶ Install the OCP module, see
Concluding steps
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ Inform the customer about changed WWN, MAC, GUID and SAS
addresses, see
page 109.
▶
"Updating expansion card firmware" on page
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 106.
▶
"Configuring LAN teaming" on page
▶ If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced expansion card.
The configuration of the network settings should be performed by the
customer. For more information, see
on page 267.
268
"Removing an OCP module" on page
"Installing an OCP module" on page
"Looking for MAC/WWN/GUID and SAS addresses" on
Upgrade and Maintenance Manual
47.
50.
50.
65.
71.
98.
115.
"Notes on network settings recovery"
265.
262.
RX2540 M7