Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 191

If the PCIe SSD module is controlled by a RAID controller of the PRAID
EP5xxi/CP5xxi/EP6xxi family, the PCIe SSD module can be installed
during operation (hot-plug), see
module" on page
CAUTION
All HDD/SSD modules (drives) must be uniquely identified so that they
can be reinstalled in their original bays later. If this is not done, existing
data can be lost.
Some SSDs / PCIe SSDs have a write life (limited life component). Ask
the customer to check the write status before replacing the spare part. If
the product has reached the end of its life, ask the customer to purchase
it again.
For Japan, refer to the following:
https://jp.fujitsu.com/platform/server/primergy/support/parts/#parts2
Preliminary steps
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Locating the defective server" on page
▶ Identify the physical location of the PCIe SSD module, see
SSD configurations" on page
▶ Prepare the removing of the PCIe SSD module.
▶ Depending on your configuration and OS:
page 50.
Removing the defective 2.5-inch PCIe SSD module
▶ Remove the PCIe SSD module, see
modules" on page
▶ If the new PCIe SSD module does not have an installation frame, replace
the installation frame,
on page 138.
RX2540 M7
Hard disk drive (HDD) / solid state disk (SSD)
181.
165.
188.
"Handling HDDs or SSDs without installation frame"
Upgrade and Maintenance Manual
"Removing a 2.5-inch HDD/SSD
47.
"Shutting down the server" on
"Removing 2.5-inch PCIe SSD
49.
"2.5-inch HDD/
191