Rear Vga Connector; Replacing The Rear Vga Connector - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

Installing the new serial interface
▶ Install the serial interface, see
Concluding steps
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
16.3

Rear VGA connector

16.3.1

Replacing the rear VGA connector

Upgrade and Repair Unit
(URU)
– Phillips PH2 / (+) No. 2 screw driver (for cover 2)
Tools:
– Hexagon screw driver 5 mm
Preliminary steps
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove the riser module 2, see
RX2540 M7
"Installing the serial interface" on page
59.
65.
71.
50.
"Removing a riser module" on page
Upgrade and Maintenance Manual
Additional interfaces
71.
Hardware: 5 minutes
50.
55.
479.
49.
72.
485