Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 312

Expansion cards and backup units
Figure 179: Installing the expansion card in a riser module
▶ Carefully insert the expansion card into the desired PCIe slot and press
down firmly until it is fully seated in the slot.
▶ If applicable, install SFP+ transceiver modules into the new expansion card,
see "Installing SFP+ transceiver modules" on page
▶ If applicable, connect the FBU cable to the FBU, see
page 321.
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
Concluding steps
▶ Install the corresponding riser module, see
page 74.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
312
59.
65.
Upgrade and Maintenance Manual
252.
"Installing an FBU" on
"Installing a riser module" on
RX2540 M7