Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 220

Hard disk drive (HDD) / solid state disk (SSD)
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Removing the air duct" on page 80
▶
"Removing the fan cage" on page
▶ If applicable, remove the riser module 2, see
page 72.
▶ If applicable,
"Removing the SAS expander board holder" on page
If the SAS expander board is installed, ensure that none of the cables
are strained or damaged during the installation of the M.2 interposer
board.
Installing the M.2 interposer board
Figure 111: Installing the M.2 interposer board
▶ Position the M.2 interposer board on the four standoffs of the chassis (see
circles).
▶ Fasten the two screws (see orange circles).
220
50.
76.
Upgrade and Maintenance Manual
50.
55.
"Removing a riser module" on
208.
RX2540 M7