Table of Contents
Advertisement
Toothed belt
Fig. 85: Changing the lower toothed belt (1)
(1) - Screws
(2) - CAN cable
(3) - Cable oil level indicator lighting
(4) - Cable thread trimmer (optional, only on
6. Pull the cables off the PCB:
7. Pull the cable (9) out of the terminals.
8. Loosen the screws (1).
9. Remove the holder (8) with the PCB.
Important
Make sure not to lose the nut (6).
Service Instructions D867 e-con - 00.0 - 08/2023
①
②
③
①
④
⑤
⑥
2-needle machines)
• CAN cable (2)
• Cable oil level indicator lighting (3)
• Cable thread trimmer (4) (optional)
• Cable thread trimmer (5)
• CAN cable (7)
(5) - Cable thread trimmer
(6) - Nut
(7) - CAN cable
(8) - Holder
(9) - Cable
①
⑨
⑧
⑦
①
105
Advertisement
Table of Contents
