Setting The Puller Parameters - Dürkopp Adler D867 e-con Service Instructions Manual

Programming

19.4.16 Setting the Puller parameters

The puller is a piece of optional additional equipment and designed to
support the feed of the sewing material. When the puller is activated,
the following settings can be made.
Icon
Service Instructions D867 e-con - 00.0 - 08/2023
Menu items
Puller
Automatic raise
Mode for raising the puller automatically
Raise by
quick stroke adjustment
nd
When the 2 foot stroke is activated, the
roller is raised automatically.
Lowering delay length
Lowering of the roller after seam beginning;
depends on stitch length and application.
Delay lowering after foot
lifting
Delay when lowering the roller after foot
lifting.
Delay lifting after foot
lifting
Delay when raising the roller after foot
lifting.
Mode
Setting defining which roller is supposed to
run.
Feeding method
Value range
• Value range
On/Off
• Value range
• Off:
No automatic raising.
• During sewing foot lift:
While the sewing foot
is being lifted.
• On Tack:
When sewing the
bartack.
• On Tack and during
sewing foot lift:
When sewing the
bartack and lifting the
sewing foot.
• Value range
On/Off
• Value range
000.0 – 999.9 [mm]
• Value range
0000 – 1000 [ms]
• Value range
0000 – 1000 [ms]
Top
The upper roller runs
actively under power.
Top + Bottom
Both wheels run actively
under power.
constant = even
transport
intermittent = trans-
port adapted to the
rhythm of the feed dog
147