Setting The Material Thickness Detection Parameters - Dürkopp Adler D867 e-con Service Instructions Manual

Programming
Icon

19.4.18 Setting the Material thickness detection parameters

Various settings can be made for the material thickness detection.
The possibilities are explained in more detail in the table.
Icon
Service Instructions D867 e-con - 00.0 - 08/2023
Menu items
Speed (Height)
Travel speed of the edge guide for the
height
Only visible for Edge Guide Mode
2-Axes
Min. Height
Smallest possible distance between throat
plate and edge ruler / roller
Only visible for Edge Guide Mode
2-Axes
Switch off collision protection • Value range
Menu items
Material thickness detection
Hysteresis
Tolerance at which the material thickness
nd
detection based on the 2
nd
the 2 needle thread tension and/or the
nd
2 sewing foot stroke switches back.
This tolerance is designed to ensure that
there is no constant alternating between
activation and deactivation in the boundary
range.
Pressure compensation
With extremely thick material, the foot
pressure increases above the standard set
value due to the material thickness.
To a certain extent, the machine can com-
pensate itself for the influence of thick
material.
Fabric compensation in bartack
Perfect Quality Sensor (PGS)
active
Value range
• Value range
05000 - 60000 [Hz]
• Value range
0.1 - 12 [mm]
On/Off
Value range
• Value range
On/Off
• Value range
0.0 – 2.0 [mm]
stitch length,
Only visible for
Material thickness
detection active
• Value range
On/Off
Only visible for
Material thickness
detection active
• Value range
On/Off
• Value range
On/Off
151