Table of Contents
Advertisement
Short thread trimmer (KFA)
Adjusting point in time for cutting
Fig. 75: Adjusting point in time for cutting (2)
(5) - Control cam
To adjust the point in time for cutting:
1. Loosen the threaded pins (6) on the control cam (5).
2. Move the control cam (5) towards the set collar (4) until it makes contact
3. Tighten the threaded pins (6) on the control cam (5).
4. Check and, if necessary, correct the cutting position.
Service Instructions D867 e-con - 00.0 - 08/2023
and correct the position of the control cam (5) by turning.
⑤
93
Advertisement
Table of Contents
