Performing The Basic Settings Of The Hook Support - Dürkopp Adler D867 e-con Service Instructions Manual

Maintenance

20.4.2 Performing the basic settings of the hook support

After disassembling the hook support, e.g. for retooling the thread trimmer,
you need to restore the basic settings of the hook support.
Fig. 144: Performing the basic settings of the hook support
(1) - Socket
(2) - Set collar
(3) - Threaded pin
To perform the basic settings of the hook support:
1. Slide the hook shaft (6) into the socket (1) of the hook support in such
 The flat (5) is centered in the slot of the socket (1).
2. Slide the set collar (2) along the hook shaft (6) and onto the socket (1).
3. Push the set collar (2) up against the hook support.
4. Tighten the threaded pin (3) on the flat (5) of the hook shaft (6).
Service Instructions D867 e-con - 00.0 - 08/2023
①
a way that the flat (5) of the hook shaft (6) can be seen in the slot of
the socket (1).
② ③
(4) - Thread trimmer cam
(5) - Flat
(6) - Hook shaft
⑥
⑤
④
215