Adjusting The Torque - Dürkopp Adler D867 e-con Service Instructions Manual

16.2 Adjusting the torque

Fig. 82: Adjusting the torque
(1) - Slot
(2) - Marking point
Proper setting
The machine is set at the factory such that the torque is 8 Nm when
the marking point (2) is exactly above the slot (1) of the washer.
To adjust the torque:
1. Tilt the machine head ( p. 18).
2. Loosen the screw (3).
3. Using the screw driver, turn the washer on the slot (1) so that 8 Nm is
4. Tighten the screw (3).
102
NOTICE
Property damage may occur!
If you change the torque, it could be that the safety release clutch will
not disengage although this would be required.
This could cause machine damage, e.g. in the event of the thread
jamming.
Do NOT change the factory adjustment.
Make sure that the torque remains at 8 Nm.
reached for the torque.
• Increase force: turn in the + direction
• Decrease force: turn in the - direction
Adjusting the safety release clutch
① ②
(3) - Screw
Service Instructions D867 e-con - 00.0 - 08/2023
③