Dürkopp Adler D867 e-con Service Instructions Manual page 229

Troubleshooting
2421
2422
2430
2431
2471
2472
2473
2474
2475
2476
2477
2478
2479
2480
2481
2483
2484
2485
2487
Service Instructions D867 e-con - 00.0 - 08/2023
Code Type Meaning
Error Stepper card X60 encoder plug
(Sub-D, 9-pin) not connected
Error Stepper card X60 flywheel position
not found
Error Stepper card X60 not responding
Error Stepper card X60 initialization failure
Error Stepper card X60 Watchdog
(Edge guide)
Error Stepper card X60 motor overload/
overvoltage/overcurrent (Edge guide)
Error Stepper card X60 Sewing motor
encoder not connected (Edge guide)
Error Stepper card X60 sewing motor
encoder not initialized (Edge guide)
Error Stepper card X60 init position not
found (Edge guide)
Error Stepper card X60 not enabled
(Edge guide)
Error Stepper card X60 overload
(Edge guide)
Error Stepper card X60 encoder failure
(Edge guide)
Error Stepper card X60 Current sensor
failure (Edge guide)
Error Stepper card X60 Incorrect stepping
motor direction of rotation
(Edge guide)
Error Stepper card X60 reference drive
failure (Edge guide)
Error Stepper card X60 overcurrent
(Edge guide)
Error Stepper card X60 parameter
initialization (Edge guide)
Error Stepper card X60 insulation error
(Edge guide)
Error Stepper card X60 transport interval
failure (Edge guide)
Corrective
• Connect encoder cable to the
control, use correct connection
• Check stepper motor 1 for stiff
movement
• Perform software update
• Replace the control
• Perform software update
• Check selection of class
• Perform software update
• Check selection of class
• Check selection of class
• Replace the control
• Replace encoder
• Replace stepper motor
• Replace the control
• Perform software update
• Check selection of class
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace the control
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace encoder
• Replace the control
• Replace encoder
• Check if plugs have been mixed up
• Check the wiring in the machine
distributor and change it if
necessary
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace the control
• Perform software update
• Check selection of class
• Check motor phase and PE for
low-impedance connection
• Replace encoder
• Replace sewing motor
• Perform software update
• Check selection of class
227