Table of Contents
Advertisement
14.4 Adjusting the bobbin case support
Fig. 72: Adjusting the bobbin case support
(1) - Bobbin case support
(2) - Counter blade support
Proper setting
The front edge of the bobbin case support (1) is flush with the nose of
the bobbin case.
To adjust the bobbin case support:
1. Loosen the screw (3) on the bottom side of the hook bearing.
2. Turn the counter blade support (2) with the bobbin case support (1)
3. Tighten the screw (3).
90
①
until the front edge of the bobbin case support (1) is flush with the nose
of the bobbin case.
Short thread trimmer (KFA)
②
③
(3) - Screw
Service Instructions D867 e-con - 00.0 - 08/2023
②
Advertisement
Table of Contents
