Table of Contents
Advertisement
To adjust the point in time for cutting:
1. Tilt the machine head ( p. 18).
2. Open the throat plate slide ( p. 28).
3. Loosen the threaded pins (7).
4. Turn the handwheel until the thread-pulling knife (5) can be swung out
5. Swivel the thread-pulling knife (5) forward until the marking End
6. Execute the service routine Feed dog > Feed dog
The handwheel is at position 60°.
7. Push the control cam (3) to the left as far as it will go and against
8. Turn the control cam (3):
9. Tighten the threaded pins (7).
10. Check adjustment:
The thread must be cut at 60°.
11. Readjust if necessary.
84
by hand.
position (4) is exactly next to the tip of the counter blade (6).
movement( p. 14).
the set collar (2).
• The roller (1) runs up at the contour of the control cam (3)
• The widest extent of the control cam is at the highest point at hand-
wheel position 60°
• Insert the thread into the thread-pulling knife (5) and slowly turn
the handwheel
• Check the handwheel position at which the thread is cut
Thread trimmer (FA)
Service Instructions D867 e-con - 00.0 - 08/2023
Advertisement
Table of Contents
