Dürkopp Adler D867 e-con Service Instructions Manual page 240

9932
9933
9934
9935
9936
9937
9938
9939
9940
9941
9942
9943
9944
9945
9946
9947
9948
9951
238
Code Type Meaning
Information No program available
Information Continue with actual value?
Warning Tilt sensor active
Warning Right hook cover open
Warning Left hook cover open
Warning Needle area cover open
Warning ENG ON 4
Warning Tilt sensor active
Information Teach finished?
Information Empty bobbin right
Information Empty bobbin left
Warning Press pedal back to reactivate pedal
function
Warning Release pedal to reactivate pedal
function
Warning Press pedal back to prepare
threading mode
Warning Release pedal to start threading
mode
Warning The stitch length adjustment needs to
be calibrated.
Information Thread Tension must be recalibrated
Warning Please press Service stop
Troubleshooting
Corrective
• Automatic mode is not available
without a program. Please use
programming mode to define a
program.
• Continue winder with current value
(YES)
• Start winder with new value (NO)
• Erecting the machine head
• Close the hook cover
• Close the hook cover
• Close needle area cover
• (ENG ON 4)
• Tilt sensor active
• To finish the teach please press
pedal -2
Low hook thread quantity
• The thread supply on the bobbin is
nearly used up. Please finish the
seam and replace the empty
bobbin with a full one. Please
remove any remaining thread from
the bobbin prior to winding.
Low hook thread quantity
• The thread supply on the bobbin is
nearly used up. Please finish the
seam and replace the empty
bobbin with a full one. Please
remove any remaining thread from
the bobbin prior to winding.
• Please press the pedal backwards
(pedal-2) to reactivate the pedal
function.
• Please release the pedal to neutral
position to lower the sewing feet.
• Please press the pedal backwards
(pedal-2) to prepare for the start of
the threading mode.
• Please release the pedal to neutral
position to lower the sewing feet
and start the threading mode.
• The maximum stitch length has
changed. The stitch length must be
recalibrated.
Please recalibrate the needle thread
tension:
• Calibrate the needle thread tension
with parameter T 62 05
• Additionally on two needle
machines: calibrate the left needle
thread tension with parameter
T 62 06
• Please press the Service stop
button to activate it
Service Instructions D867 e-con - 00.0 - 08/2023