Adjusting The Height And Initial Position Of The Thread-Pulling Knife - Dürkopp Adler D867 e-con Service Instructions Manual

14.1 Adjusting the height and initial position of the thread-
Fig. 69: Adjusting the height and initial position of the thread-pulling knife
(1) - Set collar
(2) - Latch
(3) - Lever
(4) - Screw
(5) - Adjusting washers
(6) - Hook bearing
Proper setting
The thread-pulling knife (12) is positioned at the same height as the counter
blade (10).
Height of the thread-pulling knife
To adjust the height of the thread-pulling knife:
1. Fit the counter blade (10) on the knife carrier (8) and push it up against
2. Tighten the screw (9).
3. Loosen the screw (4).
4. Loosen the threaded pin (7).
86
pulling knife
①
②
③
the thread-pulling knife (12) without pressure.
Short thread trimmer (KFA)
(7) - Threaded pin
(8) - Knife carrier
(9) - Screw
(10) - Counter blade
(11) - Marking
(12) - Thread-pulling knife
Service Instructions D867 e-con - 00.0 - 08/2023
⑫
⑪
⑩
⑧ ⑨
⑦
⑥
⑤
④