Dürkopp Adler D867 e-con Service Instructions Manual page 44

Fig. 29: Adjusting the mechanical stitch adjustment (1)
(1) - Screw
(2) - Locking peg
To preset the stitch regulator gear mechanically:
1. Switch off the machine.
2. Loosen the screw (1).
3. Pull the cables out of the cable ducts (4).
4. Insert the locking peg (∅ 5 mm) (2) into the hole (3) on the motor
42
②
While doing so, make sure not to damage the cables.
bracket.
Adjusting the mechanical stitch adjustment
③
(3) - Hole
(4) - Cable ducts
Service Instructions D867 e-con - 00.0 - 08/2023
①
④