Toothed belt
17 Toothed belt
17.1 Changing the upper toothed belt
To change the upper toothed belt:
1. Switch off the machine.
2. Disassemble the front cover ( p. 20).
3. Disassemble the arm cover ( p. 19).
4. Disassemble handwheel and toothed belt cover ( p. 23).
5. Disassemble the motor cover ( p. 22).
Fig. 83: Changing the upper toothed belt (1)
(1) - Tensioning roller
6. Loosen the screw (2) on the tensioning roller (1).
The toothed belt tension is slack.
Service Instructions D867 e-con - 00.0 - 08/2023
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before changing the toothed
belt.
NOTICE
Property damage may occur!
Possible damage to the PCB, impairing the full operational
readiness of the machine.
Always wear an antistatic armband whenever you work on the PCB!
①
②
(2) - Screw
103