Dürkopp Adler D867 e-con Service Instructions Manual page 225

Troubleshooting
1206
1207
1204
1302
1330
2101
2105
2121
2122
2130
2131
2152
2171
2172
2173
2174
2175
2176
Service Instructions D867 e-con - 00.0 - 08/2023
Code Type Meaning
Information Position not reached (during bartack) • Check the controller settings and
Information Position not reached (during bartack) • Check the controller settings and
Information Position not reached (during bartack) • Check the controller settings and
Error Failure with sewing motor current
Error No response from sewing motor
Error Stepper card X30 reference drive
timeout
Error Stepper card X30 blockage
Error Stepper card X30 encoder plug
(Sub-D, 9-pin) not connected
Error Stepper card X30 flywheel position
not found
Error Stepper card X30 not responding
Error Stepper card X30 initialization failure
Error Stepper card X30 overcurrent
Error Stepper card X30 watchdog
(Stitch length)
Error Stepper card X30 motor overload /
overvoltage /overcurrent
(Stitch length)
Error Stepper card X30 sewing motor
encoder not connected (Stitch length)
Error Stepper card X30 sewing motor
encoder not initialized (Stitch length)
Error Stepper card X30 init position not
found (Stitch length)
Error Stepper card X30 not enabled
(Stitch length)
Corrective
change them if necessary
(e.g. thread trimmer setting,
belt tension, etc.)
• Check position thread lever at top
dead center
change them if necessary
(e.g. thread trimmer setting,
belt tension, etc.)
• Check position thread lever at top
dead center
change them if necessary
(e.g. thread trimmer setting,
belt tension, etc.)
• Check position thread lever at top
dead center
• Check Service Stop
• Check for stiff movement
• Replace encoder
• Replace motor
• Perform software update
• Replace the control
• Check reference sensor
• Check for stiff movement
• Connect encoder cable to the
control, use correct connection
• Check stepper motor 1 for stiff
movement
• Perform software update
• Replace the control
• Perform software update
• Check selection of class
• Check for stiff movement
• Perform software update
• Check selection of class
• Check selection of class
• Replace the control
• Replace encoder
• Replace stepper motor
• Replace the control
• Perform software update
• Check selection of class
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace the control
223