Dürkopp Adler D867 e-con Service Instructions Manual page 68

Fig. 50: Adjusting the sewing foot lifting gear (4)
(9) - Screw
13. Turn the spring clockwise using the screw (9) until the gear (7) is at
 The plates of the lifting gear are parallel to one another.
Fig. 51: Adjusting the sewing foot lifting gear (5)
(4)
14. Tension the spring clockwise by 45° using screw (9) before fixing it in
15. Use your hand to test if the gear (7) is pushed to the 0 position by
16. Assemble the PCB (3) again.
17. Attach the plug at the PCB (3).
18. Place the cover (1) of the PCB.
19. Connect the plug (2).
66
⑨
the 0 position.
- Screw
place using screw (4).
the spring.
④
(9) - Screw
Service Instructions D867 e-con - 00.0 - 08/2023
Sewing feet
⑨