Setting The Edge Guide (Edgeguide) Parameter; Setting The Material Thickness Detection (Fabric Thickness) Parameter - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

20.5.14 Setting the Edge guide (EdgeGuide) parameter

Various settings can be made for the edge guide (motor-driven). The pos-
sibilities are explained in more detail in the table.
Menu item
ON/OFF
Speed
Min. gap
20.5.15 Setting the Material thickness detection
Various settings can be made for the material thickness detection.
The possibilities are explained in more detail in the table.
Menu item
ON/OFF
Hysterese
(hysteresis)
PressureComp With extremely thick material, the foot pressure increases above the
116
NOTICE
Property damage may occur!
Sewing feet, needle, edge guide and sewing equipment can be
damaged.
ALWAYS check the distance to the edge guide and input the correct
value after changing the sewing equipment.
Setting options
Edge guide active/inactive.
Travel speed of the edge guide.
(Value range 0500 – 60000 [Hz])
Smallest possible gap between the sewing foot and the edge guide.
This will vary depending on the sewing equipment and MUST be
adjusted when changing the sewing equipment.
CAUTION
The entered value is the gap measured between the NEEDLE and the
edge guide.
(Value range 01.0 – 20.0 [mm])
(Fabric Thickness) parameter
Setting options
Material thickness detection active/inactive.
Tolerance at which the material thickness detection based on the
second stitch length, the second needle thread tension and/or the
second sewing foot stroke switches back. This tolerance is designed to
ensure that there is not constant alternating between activation and
deactivation in the boundary range.
(Value range 0.0 – 2.0 [mm])
standard set value due to the material thickness. To a certain extent,
the machine can compensate itself for the influence of thick material.
(Value range ON/OFF)
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
Programming