Table of Contents
Advertisement
Displaying the forced setting of IED
4.27
The display at the time of forced setting of IED is indicated below.
1. When forced setting is performed from both of HMI and IED, "M" mark
that shows the setting from the HMI is displayed.
remove the forced setting from the HMI, the "m" mark is displayed.
2.
The forced setting of CB / DS / ES is explained here, but it is the same
in the case of "Switch" and "Other Status".
1)
Displaying IED symbol.
If SC has received a force setting
signal from each IED, the "m" mark
that shows forced setting will be
displayed to the close of the IED
symbol on the Overview/GIS Screen.
Refer to the figure. When the force
setting of IED is released "m" mark
display will disappear.
2) Displaying Bay Information dialog.
The "m" mark is displayed in the Bay
Information dialog. When the force
setting of IED is released, "m" mark
display will disappear.
Subsequently, when you
70
6F2M2000
Advertisement
Table of Contents
