Table of Contents
Advertisement
6F2M2000
Display of average, maximum and minimum values
6.9.7
When Average is clicked, two blue cursors are displayed. The average, maximum and
minimum values of each trend data plot in the interval between the start and end points of the
two blue cursors are displayed.
The average, maximum and minimum values are calculated based not only on the plotted
points but also on all 1 minute data between the blue cursor of the specified interval.
You can change the start and the end of the interval by dragging the corresponding blue cursor
using the mouse. The time at the cursor point is indicated under the blue cursor. The blue
cursor can stop at a plotted point only. It stops at the plotted point closer to the mouse pointer
when the mouse pointer is in between two plotted points.
When Average is clicked with the blue cursor displayed on the window, the blue cursor, average,
maximum and minimum values disappear from the window.
The initial display position of the blue cursor is at both ends of X-axis of the currently displayed
window.
The cursor may disappear from the visible zone following X-axis zoom-in operation. In this case
the hair cursor cannot be seen but retains the original cursor point. When Average is clicked
twice without the blue cursor in the window, the blue cursors re-appear at both ends of the X-
axis.
24/03/2015
24/03/2015 00:00
24/03/2015 18:21
24/03/2015 23:59
24/03/2015 00:00
Figure 6.9.6 Display of Average, Maximum, Minimum values in the Trend window
333
Advertisement
Table of Contents
