Table of Contents
Advertisement
Replacing the server fan
Process overview:
Prepare the server for hardware replacement (on page 20).
1.
If installed, remove the communication board (on page 23).
2.
Remove the server drive assemblies (on page 25).
3.
Remove the middle frame (on page 26).
4.
Remove the fan
5.
Install the fan
6.
Prepare the server for operation (on page 28).
7.
Remove the server fan
Before you perform this procedure, make sure that you have a small flat-nose plier available.
Use the small flat-nose plier to disconnect the fan cable.
1.
Remove the fan.
2.
("Remove the server
("Install the server
fan" on page 45).
fan" on page 43).
Removal and replacement procedures 43
Advertisement
Table of Contents
