Table of Contents
Advertisement
To replace the component, reverse the procedure.
Removing and replacing a power supply blank
Prerequisites
Before you perform this procedure, make sure that you have the components included with the hardware kit.
Procedure
1. Power down the system (Power down the system).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the system.
3. Remove the system from the rack (Remove the system from the rack).
4. Place the system on a flat, level surface.
5. Access the rear of the system.
6. Remove the power supply blank.
Removal and replacement procedures
55
Advertisement
Table of Contents
