Removing And Replacing The Serial Port Blank - HPE ProLiant ML30 Gen10 Maintenance And Service Manual

3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. While pressing the latch on the EMI shield, pull out the blank from the bay.
To replace the component, insert the tab on the blank into the slot on the media bay.

Removing and replacing the serial port blank

Removing and replacing the serial port blank
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Remove the serial port blank.
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 52