Configuring Whether The Ltc Reader Will Display Local Time Or Utc Time In Time/Date Mode; Selecting The Format Of The Vitc Reader Time And User Bit Data; Setting The Vitc Reader Line Range - evertz 8010TM Instruction Manual

Model 8010TM SDI Time Code Master Manual
3.5.4. Configuring Whether the LTC Reader will Display Local Time
or UTC Time in Time/Date Mode
LTC RDR TZ ADJ
Ltm zone adj utc
Ltm zone adj loc

3.5.5. Selecting the Format of the VITC Reader Time and User Bit Data

VITC RDR MODE
VR mode time data
VR mode time rtime
VR mode time date
VR mode data data

3.5.6. Setting the VITC Reader Line Range

VITC RDR START
Start line = xx
Page 3-22
When the LTC RDR MODE is set to TIME DATE, the LTC RDR TZ ADJ
menu item is used to select whether the LTC Reader will display UTC
or UTC adjusted by the programmed Time Zone Offset (Local Time).
The local time will also be adjusted by the daylight savings time
adjustment if daylight savings time is in effect. See section 3.4.8 for a
discussion of daylight saving time features of the 8010TM.
Select Ltm zone adj utc to configure the reader to output its time as
UTC.
Select Ltm zone adj loc to configure the reader to output its time as
UTC adjusted by the programmed Time Zone Offset and Daylight
saving adjustment if DST Time is On. (Local Time)
The VITC RDR MODE menu item is used to select the type of
information that is contained in the time and user bits of the VITC
reader.
Select VR mode time data when the time bits contain normal time
information and the user bits contain numeric data.
Select VR mode time time when both the time and the user bits contain
time information.
Select VR mode time date when the time bits contain time information
and the user bits contain date information. The VITC RDR TZ ADJ
menu item controls whether local time or UTC will be displayed.
Select VR mode data data when both the time and the user bits contain
numeric data.
The VITC RDR START and VITC RDR END menu items are used to
select the lines that are enabled for VITC reading. VITC reading is
enabled between the lower and higher line numbers shown (inclusive).
When the VITC RDR START menu item is first selected, the starting
line number for the VITC reader will be shown. Press the left and right
(,) keys to change the starting line. Press the down () key to
select the VITC RDR END menu item. Press the left and right (,)
keys to change ending line.
Revision 1.5.1
OPERATION