5.2.
SELECTING THE DOWNCONVERTER ASPECT RATIO
DIP switches 2 and 3 are used to select one of three aspect ratio down conversion formats, and to enable
the On Screen Menu.
DIP 2
Off
On
Off
On
Later 2410MD units are fitted with a toggle switch and pushbutton to access an on screen menu system.
On these units, when DIP switches 2 and 3 are both set to the On position the aspect ratio is set using the
On Screen Menu system. There are also additional configuration items available using the on screen
menu system. See section 6. On units not fitted with the toggle switch and pushbutton, DIP switches 2
and 3 both set to the On position is an invalid switch setting.
5.3.
SETTING THE NTSC SETUP PEDESTAL ON THE ANALOG OUTPUT
DIP switch 4 is used to select whether the NTSC Setup Pedestal will be applied on the Analog Output.
The NTSC setup pedestal should not be present when operating in Japan.
DIP 3
Down Converted Aspect Ratio Format
Off
Letter Box
Off
Center crop
On
4x3 Squeeze
On
On Screen Menu Enabled
Table 5-3: Aspect Ratio Switch Settings
DIP 4
Off
On
Table 5-4: Analog Output Video NTSC Pedestal Settings
2410MD Monitoring Down Converter
Output Pedestal
Pedestal inserted
No pedestal
Revision 1.2.3
2410MD-HSN-7