Table of Contents
Advertisement
2.3.
POWER REQUIREMENTS
2.3.1. Selecting the Correct Mains Voltage
Power requirements are 115 or 230 volts AC at 50 or 60 Hz. The Multivert has a universal power supply
(and may have an optional redundant supply) that automatically senses the input voltage. Power
should be applied by connecting a 3-wire grounding type power supply cord to each power entry
module on the rear panel. The power cord should be minimum 18 AWG wire size; type SVT marked
VW-1, maximum 2.5 m in length.
Extreme caution should be used if the top cover is removed. There is risk of
!
shock from exposed live metal parts. Servicing should only be performed by a
qualified technician. If the Multivert is fitted with dual power supplies, make
sure that power is removed from both supplies before performing any work on
the unit.
The power entry module combines a standard power inlet connector, two 5 x 20 mm fuse holders and
an EMI line filter.
Figure 5: Rear Mounting
Revision 1.2
Model 3410 Multivert Manual
Page 4
Advertisement
Table of Contents
