Table of Contents
Advertisement
3.8.1. Selecting the Video Type
VIDEO TYPE
Video 422 auto
Video 422 525
Video 422 625
3.8.2. Adjusting the Output Level of the LTC Generator
LTC OUT LEVEL
Ltc level xx
3.8.3. Setting The VITC Deleter Line Range
VITC DEL START
Delete Start = xx
OPERATION
Model 8010-SIE Digital Source ID Encoder Manual
The VIDEO TYPE menu item is used to program the 8010-SIE for the
digital video format.
Select 422 auto for operation with component video with a line rate of
either 525 or 625 lines per field. The 8010-SIE will auto detect the line
rate and automatically reconfigure itself.
Select 422 525 for operation with component video with a line rate of
525 lines per field. Conforming to SMPTE 125M.
Select 422 625 for operation with component video with a line rate of
625 lines per field. Conforming to EBU Tech 3267-E (1992) or the 4:2:2
level of IUT-R 601.
The LTC OUT LEVEL menu item is used to adjust amplitude of the LTC
output. Use the
and
level setting is 35, which is approximately 1 volt peak to peak.
The VITC DEL START and VITC DEL END menu items are used to
select the lines will be erased by the VITC deleter. This function allows
existing VITC on the incoming program video to be removed prior to
inserting new VITC on the output. VITC deletion is enabled between
the lower and higher line numbers shown (inclusive).
When the VITC DEL START menu item is first selected, the starting
line number for the VITC deleter will be shown. Press the left and right
(
,
) keys to change the starting line. When either the start or end
line number is set to –- the VITC delete function is disabled. Press the
down ( ) key to select the VITC DEL END menu item. Press the left
and right (
,
) keys to change ending line.
Revision 2.2
keys to adjust. The recommended output
Page 3-20
Advertisement
Table of Contents
