Table of Contents
Advertisement
OPERATION
pressing the vertical arrow keys to select other film manufacturer codes
than are shown in. Appendix C.
reserved for ACMAID (Ink) numbered stock. When this manufacturer code
is selected, the front panel and character generator displays the edge
numbers formatted accordingly. (See section 3.10.4 for a full description of
ACMAID modes.
Note that there are may be two manufacturer codes for each film stock
manufacturer. The lower code is for 35mm and the other code is for 16mm.
When you have selected the correct manufacturer, press the ENTER key
to proceed to film type selection. The leftmost digits of the display will
indicate FILM TYPE. The film emulsion letter from the human readable
edge code is displayed along with its numeric equivalent.
vertical arrow keys ( ,
SHIFT key while pressing the vertical arrow keys to select from unknown
film types. (A '?' will be displayed to show that the film ident letter is
unknown) Note that there may be more than one film type for each letter,
so take care to select the correct numeric film type code. (See the film
emulsion code table on page 9-1 for a list of the film emulsions currently
supported)
When you have selected the correct film type, press the ENTER key to
proceed to the numeric prefix entry. The leftmost digits of the display will
indicate PREFIX and the dual functioned keys assume their numeric
values. Pressing any numeric key will place the new value into the display,
starting at the right. Leading blank digits are assumed to be zero. When
the required number of digits of prefix are entered, press the ENTER key to
complete the edge number prefix entry.
Attempts to enter too many digits will result in clearing of the display. Re-
enter the correct value and press the ENTER key. Pressing the CLR key
will cancel the prefix entry mode without changing any data.
The numeric keys return to their normal functions, and the prefix message
stops blinking when the data entry has been completed by pressing the
ENTER key or cancelled by pressing the CLR key.
Prefix entry mode must be terminated (the prefix message will stop blinking)
before any of the front panel keys will resume their normal operation.
3.10.4 ACMAID Number Entry
When KeyKode Jam is turned off, the 4025 edge code registers may be
used to hold ACMAID Ink numbers in place of the KeyKode numbers in the
character inserter and on the front panel display. They are also encoded
into the timecode and Data log outputs in place of the KeyKode numbers.
Model 4025 Film Footage Encoder Manual
A special manufacturer code (99) is
) to select the correct film type code. Hold the
Press the
Page 48
Advertisement
Table of Contents
