Enable Insertion Of Afd/Bar Data Vanc Packets On The Output Video; Set The Afd Output Line Number; Enable Insertion Of Pan-Scan Vanc Packets On The Output Video; Table 7-6: Active Format Description Parameters - evertz 7710ARC Series Manual

7700 MultiFrame Manual
7710ARC Series - SD Aspect Ratio Converter
AFD out enable
AFD output line
Pan-Scan out enable
Pan-Scan output line
Shoot and Protect
Read Pan-Scan data
set ID
Write Pan-Scan data
set ID
Priority 1
Priority 2
Priority 3

7.4.3.1. Enable Insertion of AFD/Bar Data VANC packets on the Output Video

ARC Control
SMPTE 2016 Setup
AFD out enable
enable
disable

7.4.3.2. Set The AFD Output Line Number

ARC Control
SMPTE 2016 Setup
AFD output line
12
9 to 19

7.4.3.3. Enable Insertion of Pan-Scan VANC packets on the Output Video

ARC Control
SMPTE 2016 Setup
Pan-Scan out enable
enable
disable
7710ARC-32
Enables embedding of AFD VANC packets on the output video
Sets line number to insert AFD VANC packets
Enables embedding of Pan-Scan VANC packets on the output video
Sets line number to insert Pan-Scan VANC packets
Set whether to extract the shoot and protect area of the image
Sets data set ID that will be used for incoming Pan-Scan packets
Sets data set ID that will be used for Pan-Scan VANC packet insertion
Set highest priority for SMPTE 2016 VANC packet processing
Set mid priority for SMPTE 2016 VANC packet processing
Set lowest priority for SMPTE 2016 VANC packet processing

Table 7-6: Active Format Description Parameters

This control is used to determine if AFD/Bar data VANC packets will be
embedded into the program video output. The ARC series modules will
select the AFD code and bar data that describes the destination frame
configuration in use.
anamorphic, the AFD code 0000 will be used. Packets will be inserted
on the line specified by the AFD output line control.
This control determines what line the AFD VANC embedder will use.
The range of this parameter is 9 to 19.
This control is used to determine if Pan-Scan VANC packets will be
embedded into the program video output. The ARC series modules will
select the Pan-Scan values that describe the destination frame
configuration in use and will use the Data Set ID specified in the Write
pan-scan data set ID control.
specified by the Pan-Scan output line control.
Revision 1.1
When the output image configuration is
Packets will be inserted on the line