Chapter 7 Operation Example; Programming Procedure - Mitsubishi Electric MELSEC iQ-R60DA4 Startup User's Manual

7
OPERATION EXAMPLE
This chapter describes the programming procedure and the basic program of the D/A converter module.
7.1

Programming Procedure

Take the steps described below to create a program for performing the D/A conversion. This section describes the procedures
for creating programs in the normal output mode and the wave output mode.
Normal output mode
1.
Set module parameters.
Page 31 Module parameters
2.
Create a program.
Page 36 Program examples
Wave output mode
1.
Set module parameters.
Page 40 Module parameters
2.
Configure the initial setting of the wave output function.
Page 44 Initial setting of the wave output function
3.
Create a program.
Page 47 Program examples
Using function blocks (FBs) reduces load at programming and improves the readability of programs. For
details on the function blocks, refer to the following.
 MELSEC iQ-R Analog-Digital Converter Module/Digital-Analog Converter Module Function Block
Reference
7 OPERATION EXAMPLE
30
7.1 Programming Procedure