Removing Protective Safety Shield - HindlePower ATevo Series Operating/Service Instructions Manual
Hide thumbs
Also See for ATevo Series:
- Operating/service instructions manual (164 pages) ,
- Operations (173 pages) ,
- Operating/service instructions manual (311 pages)
Table of Contents
Advertisement
HindlePower Inc
2.2.
2.2. Removing Protective Safety Shield
Removing Protective Safety Shield
To prevent injuries, the ATevo safety shield must always be installed when
charger is in operation and/or energized.
STEPS
STEPS
• A standard flat blade screwdriver is required.
• Open the ATevo front panel door to access safety shield.
• Remove the two (2) screws that attach the safety shield to the ATevo, one above AC Input
Breaker (CB1), the other below theDC Output Breaker (CB2).
• Grab the safety shield on both left and right sides, and gently lift up and off of AC Input
and DC Output Circuit Breakers.
• Reverse procedure for reinstalling the safety shield.
Copyright HindlePower Inc. 2021
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Last modified: 3 August 2023
Page 46 of 316
Advertisement
Table of Contents
