HindlePower Inc
4.1.1.
4.1.1. Understanding the Startup
Understanding the Startup
Sequence
Sequence
ATevo is pre-configured to work with most common batteries and loads without further
adjustment.
When you start ATevo for the first time, the charger will:
• Use the
FACTORY SETTINGS
tables. These settings may be changed after startup if necessary.
• Take about fifteen (15) seconds to start. Control circuitry will "soft start" ATevo, such that
DC output voltage and current increase gradually to rated values.
Copyright HindlePower Inc. 2021
(float voltage, equalize voltage, etc) listed in the following
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Last modified: 3 August 2023
Page 81 of 316