HindlePower ATevo Series Operating/Service Instructions Manual page 64

Hide thumbs Also See for ATevo Series:
Table of Contents

Advertisement

HindlePower Inc
3.1.1 ATevo Main Display
3.1.1 ATevo Main Display
A back-lit Liquid Crystal Display (LCD) shows all charger status and configuration information.
The display is discussed in
3.1.2 Navigation and Control Button Group
3.1.2 Navigation and Control Button Group
This group of buttons (MENU, ESC, EDIT/ENTER, LEFT, RIGHT, UP, and DOWN) is used to
navigate through ATevo display screens, and user interface menus. Use of these controls is
discussed in
Section 3.3, Main Menu &
3.1.3 Operation Modes and Methods Button Group
3.1.3 Operation Modes and Methods Button Group
This group of buttons (DISPLAY MODE, CHARGE MODE, and EQUALIZE METHOD) is used to
select the mode of operation. Use of these controls is discussed in
Modes.
3.1.4 Alarm Section
3.1.4 Alarm Section
The alarm section consists of the discrete alarm indication LEDs, the AC ON indicator (LED),
and the ALARMS button. An alarm indicator will light when its associated alarm is activated.
The AC ON indicator is lit when ac power is detected by the Main Control Board (A1). The
ALARMS button is used to enter screens which display alarm statuses. Alarms and indicators
are discussed in
Section 7, Alarms &
3.1.5 Hindle Health System (
3.1.5 Hindle Health System (HHS
The Hindle Health System section consists of the HEALTH BUTTON (HH) and the RED and
GREEN health indication LEDs at the bottom of the panel. The Hindle Health System is
discussed in
Section 8, Hindle Health
3.1.6 AC Input and DC Output Breakers
3.1.6 AC Input and DC Output Breakers
Molded case circuit breaker protection devices are accessible via actuator cut-outs on the front
panel door.
The AC Input Circuit Breaker (CB1) is directly below the front control panel. When opened, this
device disconnects ATevo internal components from the ac voltage source, except for the
breaker terminals (CB1-L1/L2), where the ac input feed is connected.
The DC Output Circuit Breaker (CB2) is below (CB1). When opened, this device disconnects
ATevo output from the dc bus (battery) voltage.
Copyright HindlePower Inc. 2021
Section 3.2,
Display.
Navigation.
Indicators.
HHS) Section
) Section
System.
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Section 5.1, ATevo Operating
Page 64 of 316

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ja5011-51

Table of Contents