HindlePower ATevo Series Operating/Service Instructions Manual page 287
Hide thumbs
Also See for ATevo Series:
- Operating/service instructions manual (164 pages) ,
- Operations (173 pages) ,
- Operating/service instructions manual (311 pages)
Table of Contents
Advertisement
HindlePower Inc
14.3.14.
14.3.14. Replacing MOV Surge
Suppressor Board (A9)
Suppressor Board (A9)
• For Style-5054, see also Service Instruction (JD5079-00)
• Shut down and lock out all power to ATevo.
• Remove safety shield, and check with a voltmeter.
• MOV Board (A9) is bolted to the top of the circuit breaker mounting bracket.
• Remove the two (2) screws that connect the Transformer (T1) primary wire lugs to the
MOV Board (A9).
• Loosen mounting hardware, and remove old MOV Board.
• Install new (replacement) MOV Board (A9) onto breaker bracket.
• Reinstall mounting hardware to secure MOV Board to bracket.
• Reconnect Transformer (T1) primary wires to MOV Board (A9).
• Reinstall two (2) screws through lugs, and tighten nuts.
• Replace safety shield, and close front panel door.
• Restart ATevo.
Copyright HindlePower Inc. 2021
Replacing MOV Surge
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Last modified: 2 August 2023
Page 287 of 316
Advertisement
Table of Contents
