HindlePower ATevo Series Operating/Service Instructions Manual page 253

HindlePower Inc
13.3. 13.3. Forced Load Sharing – Forced Load Sharing –
Configuration Configuration
If the ATevo is ordered with the forced load sharing feature, the hardware and software
configuration will be completed at the factory. The forced load sharing Serial Communications
Adapters (A13) and software will be verified during production test.
If forced load sharing is added to the ATevo in the field, the following three (3) hardware and
software configurations will be required.
13.3.1 Installing Serial Communications Adapter (A13) 13.3.1 Installing Serial Communications Adapter (A13)
Refer to the supplementary ATevo Communications Manual
online) for more information and how to install and wire the Serial Communications Adapter.
13.3.2 Configuring Serial Communications Hardware 13.3.2 Configuring Serial Communications Hardware
The jumpers on the Serial Communications Adapter (A13) must be configured to operate in
2-WIRE RS-485 mode.
Copyright HindlePower Inc. 2021
2- 2-W W ir ire RS-485 Settings e RS-485 Settings
Jumper(s) Jumper(s) Label Label
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
(JA0102-54 PDF
Setting Setting
or JA0102-54
Page 253 of 316